Ectaco SpeechGuard TL-4 Manual de usuario descargar pdf (Pagina 21)

ECTACO SpeechGuard™ TL-4 User Manual

Use the Stylus

Tap the screen with the supplied pointing device called the stylus,

which, when not in use, is conveniently kept in a special slot at the

side of the device’s back panel (see page 5).

The stylus cap screws off for your convenience to use it as a reset

pin.

♦ Note: If, for some reason, using the stylus does not provide the

desired effect, you may need to perform touch screen

Calibration.

Perform Calibration

This screen fine-tuning procedure will help you adjust the device to

comply with stylus commands.

1. Go to the Setup section by pressing the Setup button, or just tap

on the word MENU in the upper part of the screen and then select

Settings in the appeared menu.

2. Tap

or press the Left / Right buttons to open the System

Settings screen.

3. Tap Calibration or just press the Setup button. You will see the

calibration screen with five targets, appearing one after another as

you tap them with the stylus.

4. To complete Calibration, please follow the instructions on the

screen. To skip Calibration, just press the Recognize button.

Tweak the System – Auto-off, Contrast,

Backlight

Your speech-to-speech translator has a number of features

designed to help you customize the interface. The following

sections will show you how to change the screen contrast, adjust

the auto-off time, and change the screen backlight mode.

1. Go to the Setup section by pressing the Setup button, or just tap

on the word MENU in the upper part of the screen and then select

Settings in the appeared menu.

1 2 ... 16 17 18 19 20 21 22 23 24 25

Sin comentarios

Ectaco SpeechGuard TL-4 Manual de usuario Pagina 21